1.4 3D Printer Controller Board Arduino Mega Shield Electronic Components Electronic Hobby Kit

Name : 1.4 3D Printer Controller Board Arduino Mega Shield Electronic Components Electronic Hobby Kit

Net Quantity (N) : 1

Input Supply Voltage : 12VDC; Standard interfaces (as that of the extruder); Reserved GCI like I2C and RS232; MOSFET 3 MOSFET is applied to the heater/ fan and thermistor circuit.

Another 5A was added to protect the component parts.; An 11A fuse is added to the hotbed.; Support 5 stepper drive board; The adoption of Pin Header as Pololu makes it more convenient to repair or change.; I2C and SPI are reserved for expanding; All the MOSFET can be controlled by PWM

Use the interface of the servo motor to adjust the level of the printing platform tomatically.; Adding an SD module for SD ramps module.; LED can indicate the status of the heater (the open and close of MOS).; Expandable to control other accessories.; Pololu boards are on pin header sockets so they can be replaced easily or removed for use in future designs.; 2 stepper motor for Z axis in parallel

Country of Origin : India